Pirit Heated Hose, New Series II Approx. 25'

See below for availability.

(No reviews yet) Write a Review

Pirit Heated Hose, New Series II Approx. 25'

Stay connected as the temperature drops!

Pirit Heated Hose is used to provide a constant source of water in freezing temperatures.

Features & Benefits:

  • Cold Weather Water Hose
  • Thermostatically Controlled, turns on when temperatures are below 45° F, off when temperatures are above 50° F
  • Pirit Hose has been tested to -42 degrees F (-41 degrees C )
  • Grounded Power Supply
  • Grounded Nickel Plated Brass Female and Male Coupling
  • Protective Bend Restrictors at both ends
  • Abrasion Resistant Cover
  • Knit Reinforcing
  • Heater wires are extruded directly into the hose walls for uniform heating and unrestricted water flow
  • Certifications: UL listed, MET approved, FDA approved materials
  • One-Year Warranty

Technical Specifications:

IMPORTANT: This hose is for normal farm and garden use and light commercial use only.

ELECTRICAL RATING:

25' 180 watts 1.5 amps, 120volts, 60 hertz 50' 360 watts, 3.0 amps, 120volts, 60 hertz 100' 500 watts 4.50 amps 120 volts 60 hertz

WARNING: Do not attempt to cut or splice hose—serious injury may result. Do not spray water into an electrical outlet. Severe electrical shock could result.

Color:  Orange or Blue (your hose could be either color--no choice)

 

Care and use of your PIRIT Heated Hose:

 

  • Simply unroll the hose to use just as you would a normal garden hose.
  • Screw the female end (near the electrical cord) of the hose onto your faucet. Make sure the washer is in place inside the female coupling.
  • Plug the 3-prong cord into a Ground Fault Circuit Interrupter (GFCI) or a properly-grounded 3-hole outlet that is protected by a GFCI.
  • The heater is thermostatically controlled and will not turn on unless the ambient temperature approaches freezing temperatures.
  • It is good practice to drain and unplug the hose when not in use to extend the lifetime of the hose.
  • If water is frozen inside the hose, allow several minutes for the ice to melt after plugging in the hose and before use.
  • DO NOT pull or tug the hose with excessive force as this may damage the fittings and electronic components.
  • Download User Instructions En, FR, SP (PDF format)